The author posted a question in Goods and Services
kak pravilno pripaivat pojalnikom? and got a better answer
Response from Антон Владимирович[+++++]
Response from 0[+++++]
take the solder knife and go ahead! the main thing is to be careful and qualitatively! and don't forget to sand what you will solder!
take the solder knife and go ahead! the main thing is to be careful and qualitatively! and don't forget to sand what you will solder!
Response from 0[+++++]
With rosin and aluminum.
With rosin and aluminum.
Response from 0[+]
it's very simple Take the soldering iron and plug it in Wait until it heats up then or while the iron is heating Clean the contacts you need to remove the crap Moisten them with some flux A special liquid for soldering which makes the contacts grease if you don't have it then use rosin and touch the soldering iron or rather its tip to let it flow into the soldering iron and finally solder the contacts that you put flux on to each other.
it's very simple Take the soldering iron and plug it in Wait until it heats up then or while the iron is heating Clean the contacts you need to remove the crap Moisten them with some flux A special liquid for soldering which makes the contacts grease if you don't have it then use rosin and touch the soldering iron or rather its tip to let it flow into the soldering iron and finally solder the contacts that you put flux on to each other.
Response from 0[+++++]
If you solder the boards, do not use ferrous acid, just colophony or special flux. the soldering iron should preferably be s61 or other so that the soldering iron can melt it and the soldering iron power should not exceed 65W semiconductor parts soldering for not more than 3 seconds so that they do not overheat
If you solder the boards, do not use ferrous acid, just colophony or special flux. the soldering iron should preferably be s61 or other so that the soldering iron can melt it and the soldering iron power should not exceed 65W semiconductor parts soldering for not more than 3 seconds so that they do not overheat
Response from 0[+]
The soldering iron has to be well cleaned and annealed and solder with rosin or acid
The soldering iron has to be well cleaned and annealed and solder with rosin or acid
Response from 0[+++++]
1 the surface is brazed and tinned 2 do not spare rosin 3 do not overheat parts 4 wash off the excess rosin with acetone 5 go to the internet it is written there
1 the surface is brazed and tinned 2 do not spare rosin 3 do not overheat parts 4 wash off the excess rosin with acetone 5 go to the internet it is written there
Response from 0[+++++]
experience - the son of mistakes. it's like welding, you need to put your hand into it. there are no special nuances here. the main thing is to prepare the surface and experience only experience will tell you how much flux and solder is needed. not necessarily radio technology I soldered and gold
experience - the son of mistakes. it's like welding, you need to put your hand into it. there are no special nuances here. the main thing is to prepare the surface and experience only experience will tell you how much flux and solder is needed. not necessarily radio technology I soldered and gold